Letter

[OPTICAL REVIEW Vol. 16, No. 6 (2009) 571-574]
© 2009 The Optical Society of Japan

Reflectance Measurement of Spherical Samples

Hervé PIOMBINI and Laurianne CAILLON

Commissariat à l'Energie Atomique, LE RIPAULT, F-37260 Monts, France

(Received November 28, 2008; Accepted September 16, 2009)

A device to measure reflectance has been built by the French Atomic Energy Commission (CEA). It can measure the reflectance of samples even if their shapes are spherical. This device has a good accuracy on flat samples; now, we want to show that it gives the same results whatever the sample shape may be. The measurement accuracy will be studied in another paper. For this matter, we have carried out reflectance measurements on eight ball bearings with different diameters over a spectral range (500–950 nm) to check the authenticity of the measure whatever the size of the ball bearing may be. The results were compared to ascertain the affinity between them. The differences do not depend on the diameter but on the defects on the ball bearings and their roughness. So, the reflectance of a measured sample seems independent of the curvature radius on our measuring system.

Key words: reflectometer, part in form, spectroscopy, reflectance, spherical component

© 1994-2011 The Optical Society of Japan (An Affiliate of the Japan Society of Applied Physics)
Produced, Developed, and Maintained by The Optical Society of Japan (An Affiliate of the Japan Society of Applied Physics)
Printed in Japan by Komiyama Printing Co., Ltd.

mail to Editorial Office, OPTICAL REVIEW